Hello, I´m just trying to excute the script manually to test it, but unfortunatelly aparently do nothing. The simple queues list don´t have nothing to show. What are the correct policies to run this script? Is compatible with routeros 6.34.4?. I´m trying that one of the users of the local network do...

Nobody?

Ok, thank you I will wait.

Hi to all, I need to prior the voip for my network. What would be the best strategy?. I read time ago about use vlans and in some post I found that mark packets using l7. My network is: The router: ether3(internet)-->rb750-->ppoe servers in ether4 and ether5 (all clients are under pppoe conections)....

Hello and sorry for answer in a old topic. I would like to apply this solution to my case.
I have a rb750 that have the ether3 as wan port to internet and have two ppoe servers in ether4 and ether5 where the computers are connected. I would like to priorize voip.

Thanks for the answer, I don´t use UM I just use ppp profile and users (secrets) in it. If I go to ppp/profiles I can see clearly: Name Local Address Remote Address Rate Limit (rx/tx) Only One PPPoE_3M_256K 10.XXX.0.1 Pool_PPPoE 256K/3072K 300K/3200K 256K/3072K 2 8 0 yes I asume that I know what is ...

Hello, I´m using this rate limit in the client profile of my pppoe server that it was copied somewhere in internet . I try to see in the mikrotik wiki what is all numbers but I can´t identify exactly all, especially last ones. The rate limit is configured as follow: 256K/3072K 300K/3200K 256K/3072K ...

Hope you have 64mb version of omnitik. According to my experience the 32mb versions behave somewhat weird. There is no technical limit other than your settings at wireless tabs. Don't you think that it's going to be the time to start thinking about the split to sectors? You have to take care about ...

Finally I found a solution, using mac telnet I added a ppoe client and once the conection was established I updated and upgraded the omnitik and one of the sxt in bridge. I have some questions: - Is a good praxis to have a ppoe conection over the omnitik and sxts (in bridge) to the core router? - Th...

If you are able to Mac telnet from other device then you can set whatever you need. I can do mac telnet but unfortunately I don´t know what I can do to update it. I tried the next things: - I added ip address to wlan1 and ether1 with the same range of my local ip and try to connect with a ftp clien...

Plisken may be right but essentially it depends on how you have set the omnitik up before. You might have set it in the way that it prevents any login.... In this case you would need to make reset and use some other port than ether1 for Mac login. I didn´t it, I could do login with no problem but u...

Try connect the omnitik with ether 2 => 5
Disable firewall on your pc

I need to go so high to cennect to other port because I connect the cable down that goes directly to port one.

Hi to all, here is my first post. I need to update my omnitik but I can´t do. I can´t connect with winbox because it don´t have any ip and by mac I have the next error: could not connect to ..... port 20561 timed out. I tried with secured mode and without secure mode in winbox with the same result. ...