Hi, I 've already used the pdf of Greg Sowell to setup the first IPsec configuration between the HQ and one of three sites. It was very helpfull!!! Now the remaining two sites are those with only one public static IP where I've to use the GRE with IPsec. So if I well understand now, after configurat...

Thank you BartoszP!
any idea when it comes out the version 6.30?
Any tutorial to set up GRE with IP sec?

Thank you.

Sorry but I have this problem and I don't find a solution. I find another people with this problem. I have some customer with Internet connection with only one static pubblic IP address. The provider's router have this IP and I cannot relay this IP on the RouterBoard 750GL. I find this schema from a...

Hi, I configured the VPN IPSec tunnel between 2 MTK. Following a tutorial I was able to connect the HQ site with Remote Site (RS). I have some question: I make ping test from Winbox indicating the interface from begin the traffic: so I can check interesting traffic. But, from those leaving the traff...

Hi
I flagged nat-t.
where I have to specify the remote peer?
Is there any other point in addition to the setting of IPsec?

Tnx in advance.
Paolo.

I found on the web that is better to set Router Provider in Bridge Mode and make PPPoE auth on the MTK.

Somebody have put Alice Gateway Telecom Italia Router in bridge mode?

Tnx

Hi, this is my first topic. I'm trying to make a VPN IPsec between Cisco ASA and MTK. I found more tutorial very helpful I tried with 2 sites with six public IP for each sites, and all work fine: router have a IP public 1.2.3.4, MKT the next of the pool: 1.2.3.5 I have the problem where the site hav...