Better take an screenshot, ansi colors don't get displayed correctly...

Sorry for my delay, I was traveling.
Below are a screenshot for your help / thoughts.
Best.

Better take an screenshot, ansi colors don't get displayed correctly...

Dear really sorry for my delay, I was travelling.
Below are the screenshot foryour toughts.
Thank you for your help. Best.

Start by using just 20Mhz channel width, as your spectrum is already complicated, 40MHz is never going to work. Did you reconfigure that? Connect by winbox, open a terminal and type /interface wireless spectral-history range=2400-2500 wlan1 Let it run for some minutes and post it. Hi, those were my...

Thank you for your reply. I did a firmware (3.24) and software (6.30) upgrade and apparently it is working know, even with my complicated spectrum. I am using just a 20Mhz channel width, as you recommended. I will test it for the next days and will let you know. Thank you. Best. Did you notice some...

Start by using just 20Mhz channel width, as your spectrum is already complicated, 40MHz is never going to work. Did you reconfigure that? Connect by winbox, open a terminal and type /interface wireless spectral-history range=2400-2500 wlan1 Let it run for some minutes and post it. Thank you for you...

Capture.JPG 90% of the time problems are due to interference, sometimes not due to Wifi signals. So first thing to check is spectrum, set 20Mhz channel width, and try different channels depending on spectrum analysis. 10% are due to hardware problems, first thing to check: the pigtails, make sure t...

For me RB2011 (RouterOS version 6.27) wireless works OK, we have 6 sites with it. Have you tried 6.30rc, perhaps there are problems with 6.29? Dear thank you for your reply. I was looking in the forum for any issue with the 6.29.1 and didn't find anything. But will try 6.30rc. Could you share your ...

90% of the time problems are due to interference, sometimes not due to Wifi signals. So first thing to check is spectrum, set 20Mhz channel width, and try different channels depending on spectrum analysis. 10% are due to hardware problems, first thing to check: the pigtails, make sure the MMCX conn...

For me RB2011 (RouterOS version 6.27) wireless works OK, we have 6 sites with it. Have you tried 6.30rc, perhaps there are problems with 6.29? Dear thank you for your reply. I was looking in the forum for any issue with the 6.29.1 and didn't find anything. But will try 6.30rc. Could you share your ...

For me RB2011 works excelent in every scenario and room.. I have -77 dbi and still have full network. I m distanced from router 15 m with walls and everything is working just fine. Dear thank you for your reply. I tested today and with -50 dbi and at 15m from the router with walls my signal dropped...

Dear iprot thank you for your reply.
I suppose that with this device specifications, would have a better/best configuration for the wireless interface.....
I hope someone could give me some tips...
Thank you.
Best.

Hi, I just started to use RB2011UAS-2HnD-IN Milrotik with RouerOS 6.29.1 as Home AP for a small office. I did a reset on the router and started to set a Home AP with the original configurations after the reset. A simple initial configuration for testing purposes. The results are below: - wired conne...