It's insantiy to use PPPoE in gigabit speeds, what are people thinking... I don't think the RB2011 can handle 1000Mbps PPPoE traffic. that's a lot of re-framing/fragmentation that needs to be handled in software. For pure IPv4 routing it surly can to much more. Maybe the RB4011 can handle it. Thank...

I did some other tests:

• cable change (two different cables, one found inside the ONT productor's box - CAT6)

• switch the ONT from ETH1 to ETH5

Nothing changed.
I also found some posts where people get 300Mbps from RB2011:
viewtopic.php?t=93553#p424314

IT runs better by disabling the "1000M full" checkbox on the Ethernet tab for the interface Eth1. The CPU loads is about 40%. The Eth 1 connects the provider's ONT to the MT with an ethernet cable. Could it be a problem in the hardware port or it's a normal behavior for a so low dimension ...

... while doing speed tests the CPU never goes over 20% ... now 34Mbps is the limit? What interface? Is your PC connected via Wifi? Nope. I've connected my PC directly thru a LAN cable from Eth2. Eth1 has a lan cable connected to the ONT. No other devices connected and no other traffic from the loc...

The RB2011 does not have CPU power for your new Internet service. Please consider the RB4011 . But while doing the speed tests the CPU never go over 20%. I understand that I will never have a 1000Mbps speed with my RB2011, but I would like to know where is the problem in the configuration. With my ...

Hi all! I just suscribed to a new FTTH service in my country (Italy). They promise 1000Mbps download and 100Mbs upload maximum speed. It is a fiber to the home, so I connected my RB2011UiAS-2HnD to their ONT box. I created a VLAN onto the eth port where I put the ONT cable, and I referred the PPPoE ...

Another working solution on 6.40.3 :# No-IP automatic Dynamic DNS update #--------------- Change Values in this section to match your setup ------------------ # No-IP User account info :local noipuser "YOURNOIPUSER" :local noippass "YOURPASS" # Set the hostname or label of networ...

Since I had some problem while updating, I decide to modify this script setting previousIP as a local variable with its IP resolved by DNS: :local previousIP [:resolve "$noiphost"]; so this is the updated script: # No-IP automatic Dynamic DNS update #--------------- Change Values in this s...