Hello,
Now that Mikrotik addressed the service providers segment with CCR routers, when does Mikrotik plan to support /31 networks?
The majority of routers used by service providers supports /31, so it will be hard to migrate from a previous /31 configuration to Mikrotik CCR routers.
Thanks,
David

Hi,

From what I see Mikrotik is expanding to carrier grade routers with CCR line.
As has support to RFC3021 is commonly used by carriers does Mikrotik has this feature on roadmap?

Thanks,
David

Hello, I think it would be a good enhancement if Mikrotik implement the following behavior: - On Routes we can define a “Check Gateway”->”Ping” to check if route is UP or DOWN. [alredy Implemented] - We are also able to set a ping through a specific interface. Ex “ping 8.8.8.8 interface=BVI329”. [al...

Hello,
On my point of view this feature enhancement would simplify configuration of route checking removing many configuration lines and making configuration easier to do and read.
Very similar to what already happens with "ARP IP targets" on ARP bond checking.

Thanks
David

Hello, On bond interface arp link monitoring is very useful when we have a switch cascade. My issue is that if I change link monitoring from mii to arp I start getting the warning below on my switchs. I think this is due to CCR1009 router periodically monitoring MAC address on both slaves interfaces...

Hello, I have a CCR1009-8G-1S-1S+, shouldn’t I be able to see the OID for Total cpu load .1.3.6.1.4.1.2021.11.52.0 like below? [aaa@bbras01-lx] > system resource print oid uptime: .1.3.6.1.2.1.1.3.0 total-memory: .1.3.6.1.2.1.25.2.3.1.5.65536 used-memory: .1.3.6.1.2.1.25.2.3.1.6.65536 cpu-frequency:...

Hello,
Can I install Cloud Hosted Router on XEN server?
If yes what image should I use?
If not is it planned to be available?
I haven’t found information about this on http://wiki.mikrotik.com/wiki/Manual:CHR

Thanks,
David Costa

Hello, I have CCR1009-8G-1S-1S+ with RouterOS 6.36.2. After I configure a full BGP /ip route print where 8.8.8.8 in dst-address it take several minutes to get a result. Should I use another command to check which path is being used to reach 8.8.8.8? Or isn’t supposed to run full bgp on a CCR1009-8G-...