I have been told during a Mikrotik training class that the SR9 card is an SR2 card with a frequency changer on it. You can test this by hooking up a routerboard with an SR9 card in it and put a laptop with a good wireless card close to it and search for networks and you should pick up a weak signal ...

I asked for help. You have done nothing but be condescending and rude. Thanks for wasting my time. If ANYONE else would care to help someone that is just asking for help. Please help.

I actually have been doing networking for several years. I have also been reading the forums and the manual for days trying to find an answer, so as not having to ask another question. I have found no solution so far. If someone could point me towards a part of the manual that i may be missing would...

I currently have a wireless Access Point setup with a public IP. It is set to work in WDS mode and is working fine and I have 1 customer that logs into it and I have another customer that can log in via the 1st customer. The both work perfectly fine. The problem is that when I try to set up a third ...

I am currently trying to setup a very simple wireless network. All I need is to be able to setup an Access Point and be able to setup customer CPEs to connect to the access point. The Access point will have a Public IP address of 66.194.196.27 and all of the CPEs will have private IP addresses in th...

I can make a perfectly good network connection and get data flowing by setting up the ports on each card as bridged and then setting the boards in WDS mode. But I cannot seem to get the boards to function passing traffic in a regular mode. I have tried reading in the Manual and it has lots of good i...

I am quite new to mikrotik and I am trying to setup a wireless network via winbox. I can get the 2 units set 1 as AP the other as CPE and I can see that they are connected to each other, but i cannot get them to ping to each other, or pass any data. please help

I am just wondering where I can get a Software Developer Kit to use with a RB112, if such exists.

I am currently still in my testing phase. I am using 2 routerboard 112 with sr-9 cards plugged in. I have each unit connected to 900 MHz antennas in the same room for testing. I have a computer connected to each board and I am interfacing with the boards via winbox. I can tell that the units are con...

I currently have purchased a routerboard 112 and an SR9 card (900MHz). I have got the Mini-PCI card installed into the routerboard. I am trying to learn what I need to do to install the software onto the routerboard so that I can make this work. I was told that MikroTik is the only company that is c...