I Upgraded to 3.24, I can see in wirelss section, wds tab, the option in "wds default bridge" the MESH interfaces previously created, doesn't appear (onlye appear bridge interfaces) until 3.23 mesh interfaces were in that list.
Is it a bug or is a change in the procedure?

Thank you

Agree.
The main point is that I checked the gateway and is exactly the same default route when I did with linux box or Mikrotik. It is a very rare problem

Regards

I have an wavecom gprs modem, and I made a configuration with ppp client in MK 115200, 8,1 hfc. The link authenticate , goes up, assign ip to ppp interface and assign the default route, but... No internet, no pings to any site, all the connections going for default route are UNREPLIED. I did the sam...

All of this in a rb532 board RouterBOOT booter 1.5 RouterBoard 532 CPU frequency: 264 MHz Memory size: 32 MB Press any key within 1 seconds to enter setup. loading kernel from nand... OK setting up elf image... OK jumping to kernel code Starting... Starting services...

I Just install this kind of cards and doestn be a valid card, there are installed the correct wireless package and license.
Any info?

I have some 5.8 GHz wireless links(include 2 nstreme-dual) , When I changed to 2.9.12 , all of the links had better performance (gain 4 or 5 dB more than he levels on 2.9.11). What is the cause of this? is that "real" or is something about counters?

Access lists in web proxy doesn't work in rc6
any info?

can you post your config?

This is the dst-nat rule to redirect to port 3128, the web proxy is running but no one packet is redirected to it. What is wrong? [admin@APTO] ip firewall nat> export # apr/11/2005 19:04:36 by RouterOS 2.9beta16 # software id = BPBQ-0N0 # / ip firewall nat add chain=dst-nat protocol=tcp dst-port=80 ...

I am trying to configure the transparent web-proxy but my natted lan doesn't appear to be working via the redirect to port 3128 dst-nat rule , I did this a lot of times in 2.8.x, any changed in 2.9 betas with the way to configure this?

I have 2 EoIP tunnels running between 2 routers.
I want to add bonding on that interfaces, when I add the bonding Interface, in the "slaves" seccion doesn't appear the eoip's interfaces, only appear the physical ethernet Interfaces.
What is wrong?

What is the limit of ethernet or like-ethernet interfaces (EoIP) Interfaces I can use with bonding?
More than two?

Do I need to reconfigure all the options when I do the upgrade, or is transparent the change?

If are there some changes in the config files between both versions , is better to copy the 2.8.19 config in a text file and paste after upgrade to 2.9

Thank you

Thank you
Worked fine

Is it posible to make a ppptp client in the part "connect to" entering a dns name and not ip address.
It because the 2 routers have a dsl connection without fixed ip address, and I was thinking in a solution based in dnstogo squema.

what is the difference in throughput configuring transparent bridging using wds or bridging eoip tunels?

Thank you