Hi,

One post is already in moderation, but during that time my new RB3011 came and I was busy with configuring it..after a while I moved unit and power went down, I touch the cable and it was ON/OFF/ON/OFF/ON/OFF so I turn it OFF, disassembled to look on power connection (was thinking about pure soldering) but everything looks good so I assembled and unit was just "ether boot" and start rebooting. I follow instructions on forum to lunch Netinstall, hold reset button etc. Everything looks OK, I see unit in Netinstall but right after I select RB3011 Packages from list disappears, so I can't select any. I can see Soft ID, Key and that is all. Any suggestions?

Issue was yesterday resolved - because of moderation I couldn't write. Problem was very easy, wrong packages.

Thank's anyway and topic can be closed