> /system/resource/print
uptime: 3m11s
version: 7.8 (stable)
build-time: Feb/24/2023 09:03:00
factory-software: 6.42.1
free-memory: 8.8MiB
total-memory: 32.0MiB
cpu: MIPS 24Kc V7.4
cpu-count: 1
cpu-frequency: 650MHz
cpu-load: 15%
free-hdd-space: 7.5MiB <--------
total-hdd-space: 16.0MiB
write-sect-since-reboot: 76
write-sect-total: 34648
architecture-name: smips
board-name: hAP lite
platform: MikroTik
> /system/package/print
Columns: NAME, VERSION
# NAME VERSION
0 routeros 7.8
> /file/print
Columns: NAME, TYPE, CREATION-TIME
# NAME TYPE CREATION-TIME
0 skins directory 1970-01-01 01:00:05
> /system/package/update/download
channel: stable
installed-version: 7.8
latest-version: 7.12.1
status: ERROR: not enough disk space, 7.5MiB is required and only 7.4MiB is free
Not enough disk space
The free-hdd-space is not seen as such by the package updater.
Re: Not enough disk space
Pretty sure it's an internal rounding issue.
Netinstall might clear the inner dungeons just enough.
Use 7.12.1 as last stop for that device. It only becomes worse resource-wise with 7.13.
Netinstall might clear the inner dungeons just enough.
Use 7.12.1 as last stop for that device. It only becomes worse resource-wise with 7.13.
Re: Not enough disk space
I experienced this particular problem myself on a hAP lite too. Just that tiny little free space I didnt have - despite I had no files on storage which I could remove to reclaim some space. I had to use netinstall back then. Tick "Keep configuration" and you're pretty much good to go.
Devices with more RAM do have RAM-disk for this, but on these old 32MB-RAM devices this is not possible IIRC. So the update-package has to fit in flash.
Devices with more RAM do have RAM-disk for this, but on these old 32MB-RAM devices this is not possible IIRC. So the update-package has to fit in flash.
Re: Not enough disk space
I made the horrible mistake of upgrading from long-term to stable.Pretty sure it's an internal rounding issue.
Netinstall might clear the inner dungeons just enough.
Use 7.12.1 as last stop for that device. It only becomes worse resource-wise with 7.13.
Remote downgrade fails.
It is not clear why netinstall should succeed, as the amount of free space does not change.
Re: Not enough disk space [SOLVED]
I used netinstall to force routeros-smips-6.49.10.npk back into the device, which I shall keep in the long-term stream.
> /system resource print
uptime: 15m39s
version: 6.49.10 (long-term)
build-time: Sep/15/2023 05:06:15
factory-software: 6.42.2
free-memory: 7.5MiB
total-memory: 32.0MiB
cpu: MIPS 24Kc V7.4
cpu-count: 1
cpu-frequency: 650MHz
cpu-load: 1%
free-hdd-space: 7.7MiB
total-hdd-space: 16.0MiB
write-sect-since-reboot: 148
write-sect-total: 69595
bad-blocks: 0%
architecture-name: smips
board-name: hAP mini
platform: MikroTik
Re: Not enough disk space
Netinstall completely formats internal flash space.
So no worries there.
So no worries there.
Re: Not enough disk space
Version 7.13.3 installed on hAP lite.
This is a device that was set aside for a manual downgrade to long-term stream via netboot. It was still connected to the network and thus cron catched it for regular updates. It is up and running. Should I expect it to malfunction and downgrade it anyway?
This is a device that was set aside for a manual downgrade to long-term stream via netboot. It was still connected to the network and thus cron catched it for regular updates. It is up and running. Should I expect it to malfunction and downgrade it anyway?
routerboard: yes
board-name: hAP lite
model: RB941-2nD
serial-number: 9D740999F72F
firmware-type: qca9531L
factory-firmware: 6.42.1
current-firmware: 7.13.3
upgrade-firmware: 7.13.3
Re: Not enough disk space
As to be expected with border cases: it depends.
How much storage is free ?
What config is on that device which may require storage space ?
...
I have devices with the same storage constraint running already stable for weeks but they're only used as access point with wave2 drivers.
How much storage is free ?
What config is on that device which may require storage space ?
...
I have devices with the same storage constraint running already stable for weeks but they're only used as access point with wave2 drivers.
Re: Not enough disk space
> ssh 192.168.1.95 '/system resource print'
uptime: 1h22m45s
version: 7.13.3 (stable)
build-time: Jan/24/2024 13:16:46
factory-software: 6.42.1
free-memory: 7.0MiB
total-memory: 32.0MiB
cpu: MIPS 24Kc V7.4
cpu-count: 1
cpu-frequency: 650MHz
cpu-load: 7%
free-hdd-space: 7.6MiB
total-hdd-space: 16.0MiB
write-sect-since-reboot: 313
write-sect-total: 77339
architecture-name: smips
board-name: hAP lite
platform: MikroTik
Re: Not enough disk space
7.6Mb storage free ?
Shouldn't be a problem for that aspect then.
Shouldn't be a problem for that aspect then.