I followed the instructions here http://wiki.mikrotik.com/wiki/How_to_Co ... _xDSL_Line
Everything works fine but I would like to use ether 3 and ether four for other computers.
They are enabled but I get no internet from them. Only on ether 2.
Can someone tell me the next step to sending signal to ether 3 and four.
thanks
Re: set up on Rb150
Create a bridge interface.
Add Eth2/3/4 to the Bridge.
Change the interface for your private IP from eth2 to the bridge interface. IP -> Addresses
Change the interface for your DHCP server from eth2 to bridge interface. IP -> DHCP Server
That should take care of it.
Code: Select all
/interface bridge add name="bridge1"Code: Select all
/interface bridge port
add bridge=bridge1 interface=ether2
add bridge=bridge1 interface=ether3
add bridge=bridge1 interface=ether4
Change the interface for your DHCP server from eth2 to bridge interface. IP -> DHCP Server
That should take care of it.