Are there any plans for support for the ZTE MF626 HSDPA USB Modem. The device is badged by Telstra in Australia and is in common usage as a general purpose USB modem. Reading between the lines it appears similar to the other existing MF62x devices.

This would be a readily available and good low cost match to the new RB433UAH.

just make a supout.rif file in the device where you have attached this, and send to support

Thanks Normis, shall do. The Rb is due in the country in a week or so.

Hello Normis

ROS tested at 3.24
My Huawei e226 runs on x86 and rb/433uah
My ZTE mf626 runs on x86 and not rb/433uah deted stores


Thank you
IDC

make the support output file and send it to support@mikrotik.com
one support output file from x86 and one after you put that in the RB433uah