HELP ! Upgraded to v2.9 and broke it
I just went to do an upgrade to v2.9 and as soon as I did it , it broke. Can not lok on to the wireless network. I can log into the winbox but not on to the wireless network. I know it's a simple thing but ... HELP !
what about your router?it is pc router or routerboard?
I have the same problem. Probably after upgrading you have only system package only.
Look /sys pack pri
How to solve this I don't know
May be need to upload additional packages. But now i have only telnet access beacose wireless is broken and i'm going via proxy's mapper.
Tomorrow i'll try to upload.
Look /sys pack pri
How to solve this I don't know
May be need to upload additional packages. But now i have only telnet access beacose wireless is broken and i'm going via proxy's mapper.
Tomorrow i'll try to upload.
When upgrading from 2.8 to 2.9, do NOT use the all in one package. The first time it boots as the version upgrade occurs, it ONLY installs the system package from the all in one package, nothing else. If you can get access to the unit again, install the all in one package a second time and it will then install everything, but the only access you've got to the box until then is via the ethernet ports. One other thing, you'll also discover that all of your wireless config has vanished and that you need to redo it.
The way around this is to install the individual packages during the version change. They all get installed then correctly and the config stays intact.
I spent a few hours recovering a remote AP yesterday and then experimenting in our office to figure out what was going on and what would work correctly.
The way around this is to install the individual packages during the version change. They all get installed then correctly and the config stays intact.
I spent a few hours recovering a remote AP yesterday and then experimenting in our office to figure out what was going on and what would work correctly.
If I install it this way and restore my backup from v8.28 will all of my setting remain?When upgrading from 2.8 to 2.9, do NOT use the all in one package. The first time it boots as the version upgrade occurs, it ONLY installs the system package from the all in one package, nothing else. If you can get access to the unit again, install the all in one package a second time and it will then install everything, but the only access you've got to the box until then is via the ethernet ports. One other thing, you'll also discover that all of your wireless config has vanished and that you need to redo it.
The way around this is to install the individual packages during the version change. They all get installed then correctly and the config stays intact.
I spent a few hours recovering a remote AP yesterday and then experimenting in our office to figure out what was going on and what would work correctly.
-
-
wildbill442
Forum Guru
- Posts: 1055
- Joined:
- Location: Sacramento, CA
Who is online
Users browsing this forum: Partial and 30 guests