Community discussions

MikroTik App
 
Red0ktober
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 56
Joined: Fri Jun 26, 2009 8:42 pm

Migration Path for Established ISP, and other questions...

Thu Dec 03, 2009 1:56 am

I've posted before with some beginner questions, having brought in an RB450G to bench test and demonstrate the advantages of PPPoE over our current methods. I have done that, and now I'm committed. I have the RB450G going out into the field the week, with another RB450G and an RB1000U being delivered tomorrow. I've run into a couple other issues that I don't have answers for...

1) It's not recommended that you run static IPs and DHCP alongside PPPoE for security reasons, HOWEVER I have an existing WISP with Trango Broadband equipment. Each AP and each SU/Client has a static (private) IP, if I have these on a PPPoE interface, I lose visibility to them, though the PPPoE clients (consumer routers) beyond work fine. Those static addresses don't need to get out to the internet, just be visible on the network for troubleshooting, snmp access, FW updates, etc.

2) We run NAT on our core router with three vlans, one for each of the geographical areas we serve. These addresses are spread among many towers and APs, and are hand entered static addresses in the customer routers. To migrate over to PPPoE, I need to allow this NAT pool to run alongside the PPPoE, and still get out to the internet while we go through the tedious process of changing over each individual subscriber's router to PPPoE. We provide a router with our service and we used to do a lot more hand-holding, so we have remote management to almost all the subscriber routers. Any ideas how I can migrate?

3) I'm confused as to how the switch functions relate to the PPPoE and routing functions. How do I assign a PPPoE service to a specific VLAN? Our network is switched at this time, but we have managed switches everywhere. The original idea was to have a core mikrotik device routing our network through individual VLANs from each AP, instead of one vlan being shared by many APs and towers.

I'm sure I'll ask more questions as the come up. Thanks for the help! :)

-Paul
 
Red0ktober
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 56
Joined: Fri Jun 26, 2009 8:42 pm

Re: Migration Path for Established ISP, and other questions...

Fri Dec 04, 2009 3:07 am

I have the RB1000U installed with the User Manager package loaded. Be installing a WiFi AP for PtMP fixed-wireless with a RB450G (overkill) beneath it.

The RB1000U will be taking a more active role for the rest of the network, once I test a workable migration strategy.

Who is online

Users browsing this forum: lonthong2002 and 23 guests