Iv been playing with the Microtik RouterBoard 750 for some time now and cant seem to get it working to access internet.
First a bit on my network. I have a satallite modem that connects in Port 1, port 2 is then for the local network and should have addresses in the 10.0.0.* range, port 3 is the public network and should have in the range 192.168.1.*.
Now i have gone through everything and been able to set up dhcp so when i plug in my laptop into port 2 i get an address, but i get no internet. Little help please.
Re: Configuration
so port 1 has the internet settings correctly, then port 2 has 10.0.0.1. It works fine and i get internet and all. Port 3 now is the problem, its set to 192.168.1.1 but i get ip addresses in the range 10.0.0.*. Why is that?
-
-
ciphercore
Member Candidate
- Posts: 155
- Joined:
Re: Configuration
Do one of these and post output.
Code: Select all
/interface ethernet print
Re: Configuration
you have either a bridge or a switch configured, you must disable that. post your ethernet settings, as the above poster asked
Re: Configuration
Code: Select all
[admin@MikroTik] > /interface ethernet print
Flags: X - disabled, R - running, S - slave
# NAME MTU MAC-ADDRESS ARP MASTER-PORT SWITCH
0 modem 1500 00:0C:42:5A:7D:7A enabled
1 R local 1500 00:0C:42:5A:7D:7B enabled none switch1
2 RS public 1500 00:0C:42:5A:7D:7C enabled local switch1
3 S ether4... 1500 00:0C:42:5A:7D:7D enabled local switch1
4 S ether5... 1500 00:0C:42:5A:7D:7E enabled local switch1
any ideas?
Who is online
Users browsing this forum: No registered users and 94 guests