To make a LAN over public network.
But when I create the bridge and add the VPLS interface "vpls1".
It show "disabled port" (see the image below). What is the problem ? Thank you.
-
-
200120022003
newbie
- Posts: 25
- Joined:
Transparently Bridge two Networks using MPLS
I follow this tutorial : http://wiki.mikrotik.com/wiki/Transpare ... using_MPLS.
To make a LAN over public network.
But when I create the bridge and add the VPLS interface "vpls1".
It show "disabled port" (see the image below). What is the problem ? Thank you.
To make a LAN over public network.
But when I create the bridge and add the VPLS interface "vpls1".
It show "disabled port" (see the image below). What is the problem ? Thank you.
-
-
200120022003
newbie
- Posts: 25
- Joined:
Re: Transparently Bridge two Networks using MPLS
The status of the VPLS interface shown as below.
The remote label and the local label is the same.
I see the tutorial is not the same number. Why ?
The remote label and the local label is the same.
I see the tutorial is not the same number. Why ?