I found what my problem was.

2 bridges back to back.
1 5.8 Turbo at 5765
Other 5.8 at 5825.

I disabled turbo and pushed it to 5745 and both links are good.

If I wanted to run turbo on both, what kind of freq separation would I need? About 40 MHz.

But remember, the freq you mention is the center freq,

eg : 5825 --> (from 5805 s/d 5845 MHz)
eg : 5765 --> (from 5745 s/d 5785 MHz)

So actually the freq doesn't overlap at all,
but in your actual experience you gettting bad performance,
maybe because other wireless network in your vicinity.

Try checking using spectrum analyzer, because
propertiary wll often doesn't come in MT scan
or frequency monitor.

Thx
//Budi

This is what the link looked like.

(----------------5825--------------------)(-----5765 Turbo----)

My long link was getting interferance from the back lobe of the bridge and also from the remote end of the turbo shooting thru it.

It is now setup like this:
(----------------5825--------------------)(--------5745--------)
and is working good