Hi,

in this situation (attachment), where should I set proxy-arp in order to reach the ap's in the end? (the part inside the orange lines is repeted 4 times from the switch)

I already tried several configs, but I can't make it work ok



thanks!

sorry about my english..

Is there any way you could be convinced not to run a /21 over a series of four wireless bridges?

Because that will never work well. Migrate to a routed network.

the problem is, in the router (10.0.0.1) is the pppoe server and behind the ap's in the end are the
clients, later I must replace the private ip's for a public pool, all the routers in the way act as
brdiges with a managment vlan(172.16.0.0/21) and a a pppoe vlan, the ap's in the end (ubnt rockets)
don't support vlans so for now I must set an ip of the pppoe subnet in order to reach it...


thanks!

the problem is, in the router (10.0.0.1) is the pppoe server and behind the ap's in the end are the
clients, later I must replace the private ip's for a public pool, all the routers in the way act as
brdiges with a managment vlan(172.16.0.0/21) and a a pppoe vlan, the ap's in the end (ubnt rockets)
don't support vlans so for now I must set an ip of the pppoe subnet in order to reach it...


thanks!

FWIW, I use some UBNT bullets and you can do VLANs, just not through the web interface. Just make a script that runs. Have WDS working w/ a management VLAN on them and the ethernet port bridged to another vlan of the WDS.

can you post your config please?

i dont have any now , my setup it is just with one ip that i got from my provider i actualy i got 5 static ip.

can you post your config please?

i got just a bandwidth control and few other rules but nothing special

i dont have any now , my setup it is just with one ip that i got from my provider i actualy i got 5 static ip.

can you post your config please?

I think you're in the wrong post