Hi to all, I have a problem with my RB411 board look like i disable ether1 with winbox not its not seeing the RB, how can i reset it to default?

Nicmo

You can enter the board via COM port and enable ether1. It's not necessary to reset the board.

Thanks for the reply, I tried to connect via com port but the screen auto scrolls. Any suggestions?

Nicmo

Did you select a baud rate of 115200? Access through the serial port should always work.

Yes I did.

115200 and press enter in Terminal... and It should work : /

you can enter terminal and connect the board.. then you'll see letters, if you see symbols, try another baud rate.

Maybe the cable was too long so i build a shorter one and it works great.
Thanks for all the suggestions.