!!!OK!!!

For some reason, HT-Extension-Channel is disabled by default. Now running 270 Mbps/243 Mbps.

=====

THANKS in advance for posting a RouterOS configuration which achieves the speeds mentioned by http://www.mikrotik.com/download/share/newsletter30.pdf and http://www.routerboard.com/index.php?showProduct=108.

I'm sure it is a cockpit error, but the highest over the air rate I have seen in a lab environment is 130 Mbps. That was for 5 meter spacing, power at 0 dBm, resulting in signal strength of -55 dBm.

RouterOS V5.0.

The configs are below the sig.

Thanks for telling us what we need to change in order to achieve 200 Mbps over the air speeds.

kind regards/ldv

===near end of link===

[admin@MikroTik] > /interface wireless print
Flags: X - disabled, R - running
0 R name="wlan1" mtu=1500 mac-address=00:0C:42:96:B4:F0 arp=enabled
interface-type=Atheros 11N mode=bridge ssid="MikroTik" frequency=5180
band=5ghz-onlyn channel-width=20mhz scan-list=default
wireless-protocol=nv2 wds-mode=disabled wds-default-bridge=none
wds-ignore-ssid=no bridge-mode=enabled default-authentication=yes
default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0
hide-ssid=no security-profile=default compression=no
[admin@MikroTik] >

===far end of link===

[admin@MikroTik] > /interface wireless print
Flags: X - disabled, R - running
0 R name="wlan1" mtu=1500 mac-address=00:0C:42:B5:65:69 arp=enabled
interface-type=Atheros 11N mode=station-bridge ssid="MikroTik"
frequency=5180 band=5ghz-onlyn channel-width=20mhz scan-list=defau
wireless-protocol=nv2 wds-mode=disabled wds-default-bridge=none
wds-ignore-ssid=no bridge-mode=enabled default-authentication=yes
default-forwarding=yes default-ap-tx-limit=0
default-client-tx-limit=0 hide-ssid=no security-profile=default
compression=no
[admin@MikroTik] >