2.9.10 and bridge problem

ianek · Sun Dec 25, 2005 5:18 pm

Hello,
i see little problem. I upgraded to 2.9.10 on rb532 and the bridge interface is not showing tx/rx rates and after some time the traffic is stopping to go throught the interface. After reboot the traffic flows again for sometime / half a day.
Anyone else see same problem ? What to do ?

Ianek

cibernet · Mon Dec 26, 2005 4:42 am

In some routers we have the same problem... but traffic passthrough without problems. We are using 2.9.10

gerd · Mon Dec 26, 2005 1:57 pm

dito here... as written in another thread here....also after reset to factory defaults...

ianek · Mon Dec 26, 2005 2:23 pm

Seems i found solution. Simple disable and enable bridge interface.... suddenly winbox shows rates and traffic go through for day now ....
Same in 2.9.9

Ianek

cibernet · Tue Dec 27, 2005 3:16 am

Seems i found solution. Simple disable and enable bridge interface.... suddenly winbox shows rates and traffic go through for day now ....
Same in 2.9.9

Ianek

The problem still persists.....

wiki · Sat Jan 07, 2006 6:47 am

exactly the same problem here, it's bad but still after nearly two years with mikrotik i can honestly say this is the first time i have a problem with their software

wiki · Fri Jan 13, 2006 1:34 pm

upgraded to 2.9.11 and everything is well again

easic · Sun Jan 15, 2006 7:03 pm

Recently upgraded from 2.9.7 to 2.9.11, experiencing the same problem with bridges..

Mon Jan 16, 2006 11:54 am

could you tell more detailed what exactly doesn't work with the bridges in v2.9.11?

ianek · Wed Jan 18, 2006 1:06 am

could you tell more detailed what exactly doesn't work with the bridges in v2.9.11?

Well i dont see the rx-tx rates in the interface box = it is not big problem.
The problem is i tried to switch to ospf and ospf dont 'see' all ip addresses included in bridge interface. When i disable enable the bridge via terminal - not winbox , it is ok. But after reboot - same problem.
Strange is that it appear only on few rb532 , some newer i got it is ok ....

Ian

gerd · Sun Jan 22, 2006 4:16 pm

same to me.... (my rb532 is from dec05) but it's enough e.g.
i have wireless bridged to eth1 and bridge1 has an ip .. i i move ip to ethernet (that i can stay connected via winbox) and then traffic is shown on bridge interface then i move back ip to bridge and its still shows the traffic...
until next reboot

(
that traffic is not shown in winbox is not really the point.. it's also not shown in the graphs

cibernet · Sun Feb 05, 2006 6:28 pm

All problems gone with 2.9.12

gerd · Mon Feb 06, 2006 11:49 am

OK.. i'll check it tonight

---------
done => it works... good job

2.9.10 and bridge problem

2.9.10 and bridge problem

persists in 2.9.11

Who is online