hi
how can we route between vlans on L3 like cisco.
for example i created Vlan 200 and 201 under ethernet 1 and set ip address 172.16.1.1 on vlan 200 and
172.17.1.1 on vlan 201.
the problem is that i cant ping interface vlan 201 from vlan 200.
what should i do?
thanks
Re: Inter Vlan Routing
When configured correctly, VLANS should just route.
Please post your config.
Please post your config.
Re: Inter Vlan Routing
just simply add vlan 700 and 704 under eth 2
and set ip address for each one
thats all
any extra configuration is needed?
and set ip address for each one
thats all
any extra configuration is needed?
Code: Select all
[admin@KavooshNet] > interface print
Flags: D - dynamic, X - disabled, R - running, S - slave
# NAME TYPE MTU L2MTU
0 ether1 ether 1500 1526
1 R ether2 ether 1500 1522
2 R ether3 ether 1500 1522
3 R Datacenter vlan 1500 1518
4 R Parse vlan 1500 1518
[admin@KavooshNet] > interface vlan print
Flags: X - disabled, R - running, S - slave
# NAME MTU ARP VLAN-ID INTERFACE
0 R Datacenter 1500 enabled 700 ether2
1 R Parse 1500 enabled 704 ether2
[admin@KavooshNet] > ip address print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 172.16.2.23/24 172.16.2.0 172.16.2.255 ether3
1 172.16.1.1/30 172.16.1.0 172.16.1.255 Datacenter
2 172.17.1.2/29 172.17.1.0 172.17.1.255 Parse
Re: Inter Vlan Routing
The problem is you have the same subnet on two routed interfaces. That's why it can't route between Parse and Datacenter. Make sure they are on different subnets, and as long as there are no firewall rules preventing it, they will route just fine.
http://www.aelius.com/njh/subnet_sheet.html
http://www.aelius.com/njh/subnet_sheet.html