Hi ,

I have a rb1100 with 5.6 and have issue with switch configuration.

I set 1 port as master , assign a dhcp server , pool , routing and firewall rules. Every work fine , but when i add a 2 port as slave to the first one , for few seconds all works , but after 10/20 sec no traffic pass , no pinging router ....


Any suggestions ?


thanks

brasileottanta

Hi,
Fewi says

Specific answers require specific questions. When in doubt, post the output of "/ip address print detail", "/ip route print detail", "/interface print detail", "/ip firewall export", and an accurate network diagram.

Hi,
Fewi says

Specific answers require specific questions. When in doubt, post the output of "/ip address print detail", "/ip route print detail", "/interface print detail", "/ip firewall export", and an accurate network diagram.

Thank for remember.