We have a Point-to-Multipoint, using Groove radios. Ver. 5.2. At the MP bridge, several vlans are available. The device is addressed on its ethernet port, using a vlan1 IP address. Bridge1 is created using wlan and ethernet ports.

Before now, we used a managed switch at each station-bridge end point, to select which vlan is ported to the customer.

At the station-bridge, we would like to manage the radio on vlan 1, and apply the vlan1 IP address to the wireless interface. At the ethernet interface, I would like to select a single vlan (NOT vlan 1). I have tried several things, but no luck so far. I can manage the station-bridge radio, but I cannot seem to get the desired vlan on the ethernet port. Is this possible ?

Thanks !

Dean

Where interface are your vlans on?