But many times the AP will see the registration of the radios but each without an IP.
My setup is shown in the figure below. I have a firewall/router which hands out DHCP to an Omnitik AP-Bridge mounted on the side of the building.
The AP-Bridge broadcasts an SSID which allows the two stations to connect.
Is there anyting missing/wrong about with my configuration?
Many thanks in advance.
The configuration of the AP-Bridge and stations is as follows:
Code: Select all
Configuration of the Omnitik AP-Bridge
--------------------------------------
[root@OmnitikWest5G] > export compact
# jul/12/2012 13:18:33 by RouterOS 5.18
# software id = XC06-WW07
#
/interface bridge
add admin-mac=00:0C:42:C3:0C:22 auto-mac=no l2mtu=1600 name=bridge-local protocol-mode=rstp
/interface wireless
set 0 band=5ghz-onlyn disabled=no ht-rxchains=0,1 ht-supported-mcs=\
mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10,mcs-11,mcs-12,mcs-13,mcs-14,mcs-15 ht-txchains=0,1 l2mtu=2290 mode=\
ap-bridge radio-name=omnitikWest5G rate-selection=legacy ssid=omnitikWest5G wireless-protocol=any
/interface ethernet
set 0 name=ether1-gateway
set 1 name=ether2-master-local
set 2 master-port=ether2-master-local name=ether3-slave-local
set 3 master-port=ether2-master-local name=ether4-slave-local
set 4 master-port=ether2-master-local name=ether5-slave-local
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk mode=dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=PASSWORD
/ip hotspot user profile
set [ find default=yes ] idle-timeout=none keepalive-timeout=2m
/interface bridge port
add bridge=bridge-local interface=wlan1
add bridge=bridge-local interface=ether2-master-local
add bridge=bridge-local interface=ether1-gateway
/interface wireless align
set active-mode=no audio-max=0 audio-min=0 frame-size=200 frames-per-second=1 ssid-all=yes
/ip dhcp-client
add disabled=no interface=bridge-local
/ip dns
set allow-remote-requests=yes max-udp-packet-size=512 servers=192.168.11.1
/ip firewall connection tracking
set enabled=no
/ip neighbor discovery
set wlan1 disabled=yes
/ip smb shares
set [ find default=yes ] disabled=yes
/queue interface
set ether1-gateway queue=ethernet-default
set ether2-master-local queue=ethernet-default
set ether3-slave-local queue=ethernet-default
set ether4-slave-local queue=ethernet-default
set ether5-slave-local queue=ethernet-default
/system clock
set time-zone-name=America/Denver
/system identity
set name=OmnitikWest5G
/system leds
set 0 interface=bridge-local leds=led5
add interface=wlan1 leds=led1,led2,led3,led4 type=wireless-signal-strength
/system ntp client
set enabled=yes mode=unicast primary-ntp=132.163.4.101 secondary-ntp=128.138.140.44
[root@OmnitikWest5G] >
Configuration of the Omnitik Station Bridge
-------------------------------------------
[root@OMNIgatecam] > export compact
# jul/12/2012 19:07:09 by RouterOS 5.18
# software id = PXSV-YX6P
#
/interface bridge
add admin-mac=00:0C:42:C3:17:E6 auto-mac=no l2mtu=1600 name=bridge-local protocol-mode=rstp
/interface wireless
set 0 band=5ghz-onlyn disabled=no ht-rxchains=0,1 ht-txchains=0,1 l2mtu=2290 mac-address=00:0C:42:C3:17:EA mode=station-bridge radio-name=\
OMNIgatecam rate-selection=legacy ssid="" wireless-protocol=any
/interface ethernet
set 0 name=ether1-gateway
set 1 name=ether2-master-local
set 2 master-port=ether2-master-local name=ether3-slave-local
set 3 master-port=ether2-master-local name=ether4-slave-local
set 4 master-port=ether2-master-local name=ether5-slave-local
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk mode=dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=PASSWORD
/ip hotspot user profile
set [ find default=yes ] idle-timeout=none keepalive-timeout=2m
/interface bridge port
add bridge=bridge-local interface=ether2-master-local
add bridge=bridge-local interface=wlan1
add bridge=bridge-local interface=ether1-gateway
/ip dhcp-client
add default-route-distance=0 disabled=no interface=bridge-local
/ip dns
set allow-remote-requests=yes max-udp-packet-size=512
/ip neighbor discovery
set ether1-gateway disabled=yes
set wlan1 disabled=yes
/queue interface
set ether1-gateway queue=ethernet-default
set ether2-master-local queue=ethernet-default
set ether3-slave-local queue=ethernet-default
set ether4-slave-local queue=ethernet-default
set ether5-slave-local queue=ethernet-default
/system identity
set name=OMNIgatecam
/system leds
set 0 interface=bridge-local
add interface=wlan1 leds=led2,led3,led4,led5 type=wireless-signal-strength
/system ntp client
set enabled=yes mode=unicast primary-ntp=132.163.4.101 secondary-ntp=128.138.140.44
/tool mac-server
add disabled=no interface=ether2-master-local
add disabled=no interface=ether3-slave-local
add disabled=no interface=ether4-slave-local
add disabled=no interface=ether5-slave-local
add disabled=no interface=wlan1
add disabled=no interface=bridge-local
/tool mac-server mac-winbox
set [ find default=yes ] disabled=yes
add interface=ether2-master-local
add interface=ether3-slave-local
add interface=ether4-slave-local
add interface=ether5-slave-local
add interface=wlan1
add interface=bridge-local
[root@OMNIgatecam] >
Configuration of the SXT Station Bridge
---------------------------------------
[root@SXTcistern] > export compact
# jul/12/2012 12:41:42 by RouterOS 5.18
# software id = QXMG-JJ89
#
/interface bridge
add l2mtu=2290 name=bridge1 protocol-mode=rstp
/interface wireless
set 0 band=5ghz-onlyn disabled=no ht-rxchains=0,1 ht-supported-mcs=\
mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10,mcs-11,mcs-12,mcs-13,mcs-14,mcs-15 ht-txchains=0,1 l2mtu=2290 mode=\
station-bridge name=wlan1-gateway radio-name=SXTcistern ssid="" wireless-protocol=any
/interface ethernet
set 0 name=ether1-local
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk mode=dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=PASSWORD
/ip hotspot user profile
set [ find default=yes ] idle-timeout=none keepalive-timeout=2m
/interface bridge port
add bridge=bridge1 interface=wlan1-gateway
add bridge=bridge1 interface=ether1-local
/ip dhcp-client
add default-route-distance=0 disabled=no interface=bridge1
/ip dns
set allow-remote-requests=yes
/ip neighbor discovery
set wlan1-gateway disabled=yes
/system clock
set time-zone-name=America/Denver
/system identity
set name=SXTcistern
/system leds
set 0 interface=wlan1-gateway leds=led2,led3,led4,led5
set 1 interface=bridge1 leds=led1
/system ntp client
set enabled=yes mode=unicast primary-ntp=132.163.4.101 secondary-ntp=128.138.140.44
/tool mac-server
add disabled=no interface=ether1-local
/tool mac-server mac-winbox
set [ find default=yes ] disabled=yes
add interface=ether1-local
[root@SXTcistern] >