I have a RB450 that is connected wirelessly to the neighbor router.
When I connected to the RB450 I can not log on D-link standing with a neighbor.
Someone who can help me with this?
Can create a drawing view is difficult and beautiful.
RB450
IP address: 192.168.1.0
D-link neighbor
ip address: 192.168.22.0
Re: RB450 wireless client config help
If the rb450 is the client of dlink...
remove all addresses from ip->address, put you rb450 all interfaces (eth & wireless) in a bridge to get all from dlink.
if you use winbox with MAC address this is not necessary...
put in the new bridge interface an address of same range of dlink or go to ip dhcp client and put in interface the bridge to get auto ip for router to login in rb450
remove all addresses from ip->address, put you rb450 all interfaces (eth & wireless) in a bridge to get all from dlink.
if you use winbox with MAC address this is not necessary...
put in the new bridge interface an address of same range of dlink or go to ip dhcp client and put in interface the bridge to get auto ip for router to login in rb450