Hi there,

I'm having problem reconnecting to my serial-terminal. I've done some configuration from RB over serial port (connected to Cisco) and as the last step I reconfigured the IP on RB. After I reconnected to RB I can't connect back to the serial-terminal I've been connected to before because it's in use. The error I get is: Any idea or help before I physically and forcibly disconnect the USB/Serial converter?

Thank You.

have you tried removing and adding again?

S

This indeed works, however I can't imagine doing this on remote router miles away.

The session has timed out after some minutes but I still wonder if I can reconnect or forcibly close the session immediately.

I think session is opened by other users who can be discconected.

Anyone knows how to disconnect inactive user session on Mikrotk?

Hi, did you find the solution? I have the same problem... already waiting 2 hours for automatic disconect...

Hi, did you find the solution? I have the same problem... already waiting 2 hours for automatic disconect...

Could anybody sove this ? I saw about 15 minutes of stuck

"serial-terminal already running on this port"

Then i managed to connect to this port ... Has anybody find solution how to remove stuck serial connection?

Hi there,

In case someone still needs this.
You can do the following steps to reset the session.

/system console disable 0
/system console enable 0
/system serial-terminal serial0