Hi There

I have buy 2 Groove 2hn router boards to setup an network bridge but how do i configure the router board. I have a telkom router and i can access it by putting 10.0.0.2 in my browser but i dont know how to access the Groove router board so the 2 can contact each other.

Regards
Darius

Why don't you start at the beginning an let us know what you're trying to accomplish? I get the impression you are trying to set up a point to point link between two networks? Do the networks have different subnets - IP addresses? Distance? What antennas are you planning on using? What are you using to access the Groove? WinBox? Or Web GUI?

-Mac