hello friends
I have wireless link with 1 RB433AH and 2minipciXR5 + two32.5dbi in every side for 16km distance but I cant see "ap bridge" side(side1) on scan page why?
my PoE output is 24v and 3A.
my config:
I have bridge1 with 3ports(ether1 , wlan1 and wlan2) and 2minipci are "ap bridge" at side1 and 2minipci are "station bridge" at side2
MMCX and LMR400 pigtails have not any problem.

Have you tried just using one XR5 each side first - and then scan + connect
Also you are using "Band" 5GHZ-A for these cards and you have set your Country also in Wireless settings?

no
i test.
thanks

my problem is resolved but i have a new problem with this radio:
when i want to connect to(webfig or winbox) my radio sometimes i can connect to it but about 30second late can see interfaces and more time when i want connect to Radio in LoggingOn message it hang and i cant connect to it, i test with MAC and IP have same problem. my ios is 6.