Is it possible no one can help me for my problem i Tried everything but its same ccq is not good but signal is good

see this pic

Is it possible no one can help me for my problem i Tried everything but its same ccq is not good but signal is good

see this pic

I hope it will help you... signal is good

Try to reduce the output power.

Try to reduce the output power.

i tray but its same ?

Try another channel.

Try another channel.

i tray but its same how moch i can make output power and u can Help me through the program TeamViewe pls

Do you have more than 1 antenna very close to each other ?

Do you have more than 1 antenna very close to each other ?

I have many of them on the tower I think that's the direction of the tower where many Noise How can I get rid of Noise


i have 3 Customer have this problem the other dont have and just in p2p

The rx CCQ being so low means that much of the information your radio is receiving is not usable. I would suspect an antenna issue or some reflection issues. Do you have something large near by that the signal could be reflecting off of? I don't think its interference because your signal to noise level is good.


Joshaven Potter
http://joshaven.com
Sent from my iPhone using Tapatalk

It also seems odd that your only showing two modulations do you have most of the others disabled? I would go back to the default modulations if you have them customized.


Joshaven Potter
http://joshaven.com
Sent from my iPhone using Tapatalk

It also seems odd that your only showing two modulations do you have most of the others disabled? I would go back to the default modulations if you have them customized.


Joshaven Potter
http://joshaven.com
Sent from my iPhone using Tapatalk

hi
if u have mail i can show u all i tray evry think but its same its just in Mikrotik RB912 i have ubnt roket no problem with this

These problems with low ccq are always from cable, antenna or interference. Don't blame the board or settings. But if you fixed the bitrate try going auto for test.