I'm tryed CapsMan features and got a problem with CapsMan manager forwarding mode .
Cap1 adapter apear in local bridge , i can ping Bridge assigned IP, but S-NAT does not work , i cannot ping any internet addresses.
I have some static routes to another networks , this netwoks i can ping too. It's seems that only i something wrong with NAT.
In my local bridge configured DHCP and some ethernet ports . If i connect directly to ether by cable , all works perfectly.
With local forward mode , all is working right.
Is it manager beta problem , or i miss something ?
Regards,
Re: CapsMan manager forwarding problem
Nobody uses capsman forwarding mode ? Please ...
Re: CapsMan manager forwarding problem
Hi shellton,Is it manager beta problem , or i miss something ?
I'd rather think you missed something - I have a very similar setuip here (with 16 caps) and it's working perfectly.
Did you configure the correct bridge in Datapath?
Are your caps in the same network you are distributing to the w/l clients?
It's pretty hard to figure out your problem without seeing your actual configuration...
Cheers
-Chris
Re: CapsMan manager forwarding problem
CapsMan RB2011
Ether1 - Out interface
bridge1 - local network
ether1 connected to internet router
bridge1 (ether9 ant ether10) , CAP connected to ether9
Cap
Cap ether1 connected to capsman ether10
CapsMan config
Cap config
PC connected by wire to CapsMan ether9 (belongs to bridge1) . All is Ok - got IP by dhcp , srcnat is working , can ping 8.8.8.8.
PC connected by wireless . I got addresses from 99.0 network by DHCP . I can ping 99.1. Can ping 34.1 (added static route to internet router 34.1, and srcnat not afected to 34.1) Ping to 8.8.8.8 - NO REPLY.
What I miss ?
Regards,
Ether1 - Out interface
bridge1 - local network
ether1 connected to internet router
bridge1 (ether9 ant ether10) , CAP connected to ether9
Cap
Cap ether1 connected to capsman ether10
CapsMan config
Code: Select all
# jan/01/2002 01:17:33 by RouterOS 6.12
#
/caps-man channel
add band=2ghz-b/g/n frequency=2412 name=channel1 width=20
/interface bridge
add l2mtu=1598 name=bridge1
/interface wireless
set [ find default-name=wlan1 ] l2mtu=1600
/caps-man datapath
add bridge=bridge1 name=datapath1
/caps-man security
add authentication-types=wpa-psk,wpa2-psk encryption=aes-ccm,tkip name=\
security1 passphrase=12345678
/caps-man configuration
add channel.band=2ghz-b/g/n channel.frequency=2412 channel.width=20 datapath=\
datapath1 mode=ap name=cfg1 security=security1 ssid=Test
/ip pool
add name=dhcp_pool1 ranges=192.168.99.2-192.168.99.254
/ip dhcp-server
add address-pool=dhcp_pool1 disabled=no interface=bridge1 name=dhcp1
/port
set 0 name=serial0
/caps-man manager
set enabled=yes
/caps-man provisioning
add action=create-dynamic-enabled master-configuration=cfg1
/interface bridge port
add bridge=bridge1 interface=ether9
add bridge=bridge1 interface=ether10
/ip address
add address=192.168.99.1/24 interface=bridge1 network=192.168.99.0
add address=192.168.34.58/24 interface=ether1 network=192.168.34.0
add address=10.0.0.1/24 interface=bridge1 network=10.0.0.0
/ip dhcp-server network
add address=192.168.99.0/24 dns-server=8.8.8.8 gateway=192.168.99.1
/ip firewall nat
add action=masquerade chain=srcnat dst-address=!192.168.0.0/16 out-interface=\
ether1 src-address=192.168.99.0/24 to-addresses=192.168.34.58
/ip route
add distance=1 gateway=192.168.34.1
Code: Select all
# jan/02/1970 00:39:22 by RouterOS 6.12
# software id = VQKC-CB3T
#
/interface wireless
# managed by CAPsMAN
# channel: 2412/20/gn, SSID: Test, CAPsMAN forwarding
set [ find default-name=wlan1 ] band=2ghz-b l2mtu=1600 rx-chains=0 tx-chains=\
0
/interface wireless cap
set caps-man-addresses=10.0.0.1 enabled=yes interfaces=wlan1
/ip address
add address=10.0.0.2/24 interface=ether1 network=10.0.0.0
/ip route
add distance=1 gateway=10.0.0.1
PC connected by wireless . I got addresses from 99.0 network by DHCP . I can ping 99.1. Can ping 34.1 (added static route to internet router 34.1, and srcnat not afected to 34.1) Ping to 8.8.8.8 - NO REPLY.
What I miss ?
Regards,
Re: CapsMan manager forwarding problem
please contact support@mikrotik.com to get access to the test release of RouterOS v6.13rc as we have made some fixed for the CAPsMAN and CAP that would help you.
Re: CapsMan manager forwarding problem
there is no reply from support ...
Re: CapsMan manager forwarding problem
please provide us with the ticket number.there is no reply from support ...
Re: CapsMan manager forwarding problem
I wrote 3 emails to support@ ant did not receive any reply ...
Re: CapsMan manager forwarding problem
we have replied to all your emails with ticket number 2014051466000486, 2014051366000111, 2014050966000665I wrote 3 emails to support@ ant did not receive any reply ...
Please check your email spam filters.
Re: CapsMan manager forwarding problem
Just tested rc13 , it's seems all is working correctly, Thank you ,
Regards,
Regards,