Hello, i can't monitor voltage and current in my RB951. When i issue this commands as you told in another post i get this:
With i get only this message:

name: ether5
poe-out-status: powered-on

Poe setting version prints 0.0 in winbox.

Would you be so kind to help me to find the problem? I think more people has the same problem than me.

Thank you very much.

RB951Ui-2HnD like all RB2011i series do not have any monitor or settings on "i" port (except PoE auto on / forced on / off).

This is not the 750UP or OmniTIK UPA-5HnD, the "i" board have only 500mV support @ 24V, just for power one SXT or Sextant.

Ah, thank you very much!

I didn't know that, i've read the wiki but maybe i didn't see it.

Thanks again!!!