Hello

i just got my first 2 new Netmetal 5 AC , and trying to configure the link .. i can not find any setup guide or symbols references .. any one can help in this .

Thanks

You can use Quickset. Open the web browser, enter the router IP address, select mode "WISP AP" and device will be configured as AP.
on the other device set mode to "CPE"

normis .. thanks for your reply

i do already configured the point to point link but i'm talking about the power levels , data rate fine tunning to get the best results

now my signal is 42/42 but the ccq not going more than 40% , BW test is 100Mbps in Tx side and 150 Mbps in rx side ,, any advice