http://www.mikrotik.com/downloadWhat's new in 1.13:
*) allow to disable SFP port;
*) do not disable SFP port if loss of signal is detected, some SFP modules
do not report it correctly;
*) make autonegotiation work better;
What's new in 1.12:
*) fixed problem - SFP port stops after ethernet port cfg change (RB260 only);
*) change default vlan mode on RB260 to 'optional';
*) fixed problem - SNMP worked even when disabled;
*) fixed problem - SFP autonegotiation setting was not saved (RB260 only);
*) fixed uptime to be correct;
*) fixed RB260GSP poe-out to work correctly after downgrade & upgrade back;
What's new in 1.11:
*) added support for RB260GSP;
What's new in 1.10:
*) allow to disable/enable auto negotiation on SFP port on RB260;
*) fixed problem - hosts tab stopped working if 0:0:0:0:0:0 was learned on RB250;
*) enable transmit on SFP port only when module with signal is detected;
*) fixed problem - port lock & lock on first did not work on RB260;
*) fixed problem - port full duplex setting was set for wrong port on RB260;
*) fixed problem - broadcast correct uptime to it's neighbors;
*) fixed problem - port egress rate did not limit traffic properly on RB260;
*) fixed problem - sometimes board did not reboot after upgrade;
*) added vlan-id to static host table;
This version fixes 1Gbit ethernet autonegotiation with Cisco 3550 and improves compatibility with SFP modules which do not have DDM.
