Hi guys

I might be missing something, but I have tried and checked and can't find a solution for this.


I recently upgraded to v6.20 and upgraded the firmware.
I click on "Or click here to see them all", which gives me about 2 seconds of route before it goes back to the same screen.
I have been able to quickly put in some filter conditions, but it goes blank after it returns to this screen.
Any advice?

Yes winbox takes too long to populate the list.
You have the option to see them all, or you can filter to find the ones you are interested in.

My most popular filter is Prefix and in XXX.XXX.XXX.XXX/XX.
Fill in the subnet and it will list all advertisements for any ranges within that range.

Yes winbox takes too long to populate the list.
You have the option to see them all, or you can filter to find the ones you are interested in.

My most popular filter is Prefix and in XXX.XXX.XXX.XXX/XX.
Fill in the subnet and it will list all advertisements for any ranges within that range.

Happens even with <100 'advertisements' so its definitely not that. It legitimately seems to be a bug, where it can't seem to open this page. I click 'View All', it populates them all on screen then half a second later goes back to 'Too Many'.

It's never frustrated me enough to log a ticket as I figured others had but If not I may do that this week.

Agreed. I think it's a bug. Same thing happens on my CCR1036 running 6.20. BGP Advertisements claim there are too many to display, but when I select "Click here to see them all" it shows all FOUR advertisements for two seconds, then goes back to "There are too many advertisements to show them all. Please specify more specific Prefix filter."

This has been confirmed as a bug in emails from Mikrotik support.

It will be fixed in v7.