Use iperf today on 2 wireless N laptop connected on a rb2011, signal strength was -40db.
Results of iperf were 8mbits/s.
Doesnt seems ok, does it?
Tried to change the following, without success:
- tx rates all the same
- bridge on/off
- channel
- completely up to date
- wpa2 aes
- N only
- 20mhz channels
i am on the phone now, but will post an config asap.
Re: Rb2011 iperf
Here are the details from the wireless interface:
Code: Select all
Flags: X - disabled, R - running
0 name="Guest@home" mtu=1500 mac-address=D6:CA:6D:E5:EC:37 arp=enabled interface-type=virtual-AP master-interface=wlan1 ssid="guest@home" wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no
bridge-mode=enabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0 hide-ssid=no security-profile=guest
1 R name="wlan1" mtu=1500 mac-address=D4:CA:6D:E5:EC:37 arp=enabled interface-type=Atheros AR9300 mode=ap-bridge ssid="wireless@home" frequency=2437 band=2ghz-onlyn channel-width=20mhz scan-list=default
wireless-protocol=802.11 wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no bridge-mode=enabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0
default-client-tx-limit=0 hide-ssid=no security-profile=default compression=no