Hello everyone
I am a new user of RB750. I am setting up NAT and get some trouble.
Below is my topology
Eth1-gateway is PPPoE out, Eth2-interface ip 10.0.0.1/24, Eth3 ip 192.168.1.230/24
Eth2 connect to a MPLS-VPN network ip range 10.0.x.x/16 gateway 10.0.0.254
Eth3 connect to company lan 192.168.1.0/24
a cisco router 192.168.1.254 connect to foreign company 172.16.0.0/16
Recently I have to set up routing from 10.0.x.x network to 172.16.0.0
cause cisco router only accept access from 192.168.1.x range
I have to setup NAT from eth2 to eth3
But when I setup srcnat I still found 10.0.x.x traffic to 192.168.1.254
Can anyon ehelp me solve this problem?
Thanks ~~