hey guys,

I'm a bit stuck on the vlan's in RouterOS.
My experience with vlan's isn't that big so maybe it is just my disunderstanding.

But this is the situation i want to create. Right now i've a temporary situation with bridges. The RB2011 is my main router. Port 1 is WAN with external IP.
Al the ports on the RB2011 need to be acces ports to vlan100-office. Without control for number of devices; Because of unmannaged switches behind port 4 and 5.
Except port 3 which has to become a trunk port to a small 'switch' the hEX lite.
Port 3,4 and 5 on the hEX lite have to be also trunkports to the following devices.
All the devices on the right side need to have acces ports to the vlan written in the device.

All the wireless is managed by CAPsMAN. The RB2011 is the manager. There are 3 wireless networks. Matching the vlan's. Right now the AP's are in manager forwarding mode with a datapath to the matching bridge. But i also want these to be routed in the vlans.

My question is, how do i set this up. I'm a bit stuck on the vlan part. Because there are so many different tutorials about how to fix this.

I hope someone of you can help me.

On RB2011 ether3 port you should configure vlan100, vlan200 and vlan300 interfaces.

Since you plan to have vlan100 access ports, you will need a bridge which will contain vlan100 interface from ether3 and necessary vlan100 access ports. The vlan100 IP address should be configured on the bridge interface.

The rest of devices you should be able to configure using examples from this article:
http://wiki.mikrotik.com/wiki/Vlans_on_ ... nvironment

Thanx, i'm gonna try it.