Hello. There's any plans of adding 10MHz channel support on AC products?

We have some PtP link running on 10MHz using Nanobridge, and we'd like to replace it with new Dynadish... but here it's difficult to find a clean 10MHz channel... and impossible with 20MHz

Other brands supports 10, 5, etc with same AC chips ("the U brand", for example)

Will it be supported? Any estimated date?

Regards

no reply? no news on this?

The lack of narrow channels is preventing me from trying AC hardware.

If it is work in progress I'll grab some to test until it is available.

another issue with ac equipment

no 10mhz channel
no spectrum analizer
no tx power control

another issue with ac equipment

no 10mhz channel
no spectrum analizer
no tx power control

I strongly hope it's only a " ..not yet " ..but time is passing by..

another issue with ac equipment

no 10mhz channel
no spectrum analizer
no tx power control

tx power works fine, its just not showing on the current tx power tab.

another issue with ac equipment

no 10mhz channel
no spectrum analizer
no tx power control

tx power works fine, its just not showing on the current tx power tab.

thx for the info