Hello,
In a WDS AP/Station pair (two MikroTik's with WDS link), which frequency is in use, the one displayed by the master unit or the one displayed by the slave unit or are both frequencies in use, respectively?
rgds/ldv
If I'm not making a mistake/cockpit error, that's why I asked - the frequencies displayed on both ends are different.I think, AP frequency is used.
Station uses AP frequency channel (AP<>station-wds),
wds-slave adapts to AP frequency channel (AP<>wds-slave),
frequency should be the same on both ends (AP<>AP).
That leads to whether we've been searching for a "clear channel" correctly.
IOW, do you have to have one or two (one each way) clear channels in order to operate?
rgds/ldv
The AP freq is in use.
The Station/Station-wds scan-freq is in use.
If you have AP freq=5200
and Station scan-freq=5100,5205
The won't connect.
If you have AP freq=5100
station scan-freq=5100,5000,5005,5010,5015,5210,5215,5220
They will connect as the station will search for all this freq and find the AP.
The Station/Station-wds freq is ignored as the AP scan-freqs are ingnored and they doesn't matter.
The Station/Station-wds scan-freq is in use.
If you have AP freq=5200
and Station scan-freq=5100,5205
The won't connect.
If you have AP freq=5100
station scan-freq=5100,5000,5005,5010,5015,5210,5215,5220
They will connect as the station will search for all this freq and find the AP.
The Station/Station-wds freq is ignored as the AP scan-freqs are ingnored and they doesn't matter.
-
-
DirectWireless
Member Candidate
- Posts: 143
- Joined:
Who is online
Users browsing this forum: gigabyte091 and 16 guests