board-name: CCR1016-12G
platform: MikroTik
who wrong i do?
Code: Select all
set numbers=7,8 master-port=ether11
failure: master-port and bandwidth settings not supported on this port
make switch problem
version: 6.33.3 (stable)
board-name: CCR1016-12G
platform: MikroTik
who wrong i do?
board-name: CCR1016-12G
platform: MikroTik
who wrong i do?
Re: make switch problem
That CCR doesn't have a switch all ports have a direct connection to the cpu, therefore you can't (and don't need to) set a master-port.
Edit: You probably just want to set up the ports in a bridge and make sure fast-path is set on.
Edit: You probably just want to set up the ports in a bridge and make sure fast-path is set on.
Who is online
Users browsing this forum: No registered users and 25 guests