Hi to all,

I have a little problem with SMB on RB951 with 6.36

The SMB works fine on LAN and other interfaces but no on WAN interface (in my case is a PPPoE client named "Telefonica_Data"). When i activate the SMB, the log show this list of interfaces and address activated but i don't see the public IP. The SMB system don't works with public IP and i think the problem is that this IP isn't activated to SMB but i don't know how activate.
I have other interface with dynamic IP and works fine, the log show this IP when the interface is activated to SMB.

Anyone can say me anything about this?




Thanks!

Hi!

Las week i discovered the solution!

I think the problem is (in my case) dynamic WAN IP because the solution is a NAT! I tried to configure NAT to internal router IP on port 445 and works fine over the world!



I hope this post help to anyone,