Community discussions

MikroTik App
  4. RouterOS
  5. General

LILO boot error

Post Reply
 
brucefet
just joined
Topic Author
Posts: 2
Joined: Fri May 28, 2004 5:42 pm

LILO boot error

Mon Jun 07, 2004 8:11 pm

I had a working licensed router. I did a reset command to clear configuration so I could load a backup from another router. After doing the reset, when it rebooted, The following message appeared and then it hung and would finish booting.
Message "LILO - Keystroke read/checksum error".
Any information as to what is wrond and what to do will be appreciated.
Top
 
brucefet
just joined
Topic Author
Posts: 2
Joined: Fri May 28, 2004 5:42 pm

mistake in post

Mon Jun 07, 2004 8:13 pm

The line should have said 'would not finnish booting'.
Top
 
jolly
Trainer
Trainer
Posts: 39
Joined: Fri Jun 11, 2004 11:41 pm
Contact:
Contact jolly

Fri Jun 11, 2004 11:55 pm

Why not try reinstalling routerOS and then restore backup, It sure solves this problem,I have tried it a couple of time and it worked
Top
 
raqu
just joined
Posts: 14
Joined: Mon May 31, 2004 12:07 am
Location: Poland
Contact:
Contact raqu

Thu Jun 17, 2004 10:23 am

Do you install mt on IDE flash disk?

If You install on flash disk try to set in motherboard setup PIO1 mode for flash disk. We had exactly the same problem with PQI 64MB Disk-On-Module which in default use PIO2 mode.
Top
Post Reply
  4. RouterOS
  5. General