please exuce me for this question but im still new in microtik ,

i just setup a link 20km direct visible bridge connection with wds

when i do ping i get a delay of 100ms and 200ms

how i can test my link spead an load


RaMi.

100 -200ms something is wrong, should be <5-10ms

You can use bandwidth test and server, have a look in tools menu (in winbox)

What is you signal level?

Can you change channel?

I have 40km link with crappy LOS and get <5ms & <20ms under load.

100 -200ms something is wrong, should be <5-10ms

You can use bandwidth test and server, have a look in tools menu (in winbox)

What is you signal level?

Can you change channel?

I have 40km link with crappy LOS and get <5ms & <20ms under load.

SIR,
signal level is -75 ~ -80

that's not a good signal, try adjusting your antennas or changing the frequency. good signal is -60

100 -200ms something is wrong, should be <5-10ms

You can use bandwidth test and server, have a look in tools menu (in winbox)

What is you signal level?

Can you change channel?

I have 40km link with crappy LOS and get <5ms & <20ms under load.

that's not a good signal, try adjusting your antennas or changing the frequency. good signal is -60

in this case can i change only the ap bridge signal ?? or i must change't in all the points , and if i change the apbridge signal thru network i will loose the connection ?

in this case can i change only the ap bridge signal ?? or i must change't in all the points , and if i change the apbridge signal thru network i will loose the connection ?

Uh, you realize you have to physically DO something (like move an antenna, or redo a cable) to change the signal, right? It's not exactly something you can change in the software, except by reducing tx-power - which you don't want to do!

At 20km with direct visible line of sight you should have, as the others said, 5-20ms pings under load and around -60 signal.

You probably need to check your pigtails, cabling, and antenna allignment.