What are the commands associated with IGMP snooping? [I'm not looking for full documentation, just some hints would be helpful. Is it applied on a per-bridge, per-port, per interface basis?]
The notes say:
!) bridge - implemented software based "igmp-snooping" (untested, undocumented, CLI only);
I am very excited to test this as I'm in the process of configuring and testing a multicast IPTV system... thank you for implementing this feature. I will do my best to test and report the behaviors I find.
Re: IGMP Snooping Configuration and Testing Information
Hello, IGMP Snooping is a per-bridge feature in RouterOS. Here is a sample of how it should look like:
Code: Select all
[admin@MikroTik] > /interface bridge set bridge1 igmp-snooping=yes
...
[admin@MikroTik] > /interface bridge mdb print
BRIDGE VID GROUP PORTS
bridge1 237.0.0.1 ether3
ether2
ether1
bridge1 238.1.1.1 ether2
ether1
[admin@MikroTik] >
Re: IGMP Snooping Configuration and Testing Information
viewtopic.php?f=21&t=123335&start=150#p608488
v6.40 is scheduled for release, so we reverted hw-offload as well as igmp-snooping, because it requires more testing and bugfixes.
Most likely it will be back in v6.41rc
Re: IGMP Snooping Configuration and Testing Information
Ok, I will try to be patient. I'm trying to setup my IPTV service and I am excited that MikroTik is finally implementing IGMP snooping.