Hi Guys,

i need a little help on CRS109 config.
Current situation:
eth1 WAN - accessible from all switch ports,
eth2 master port (connection to wAPac (on wAP DHCP off))
eth3, eth4, eth5 eth6, eth7, eth8 switching group ports

Wanted scenario:
eth1 WAN - accessible from all VLAN-s,
eth2 connection to existing wAPac,
eth3 and eth4 VLAN1, (1 computer 2 NICs, bonded)
eth5 and eth6 VLAN2, (1 computer 2 NICs, bonded)
eth7 and wlan2 (1 computer) VLAN3, (1 computer 1 NIC, 1USBWiFi, bonded)
eth8

All connected computers must be reachable via LAN.
Any other suggestion on how to achieve 2Gb connections between all 3 computers...

IIRC crossing vlans means cpu not switch-chip. Considering the cpu in the crs I don't think you'll be able too. If you had all 3 PCs in the same vlan that would've worked for sure.