problems with mikrotik router RIC 522 routerboard 112

davidefulvio · Fri May 04, 2007 1:44 pm

Hi

My name’s Davide Cocco ,I’m a student in electronic engineering in University of Cagliari(Italy) and I work with router mikrotik for my thesis and I have these problems:

When I launch winbox I can’t access a lot of menu, for example menu: ip\address, so I can’t change ip\address of Ethernet interface(ether 1) which have ip address 0.0.0.0 and also the router disconnect every 30 seconds.

I hope in a your aid

Thanks

Davide

balimore · Fri May 04, 2007 1:57 pm

---
i think, you have ID just 'read-only' permission.
try login in with Mac-Telnet or Mac-Winbox when you have problem to check your status of your group ID.
that command excute type mac-telnet [CLI]:

/user print

regards
Hasbullah.com
---

davidefulvio · Fri May 04, 2007 2:15 pm

i can't connect with telnet because the internet interface have ip address 0.0.0.0

balimore · Fri May 04, 2007 4:25 pm

i can't connect with telnet because the internet interface have ip address 0.0.0.0

---
yes ofcourse, you can connect to them with mac-telnet by download this link first: http://www.mikrotik.com/download/neighbour.zip
than install to your pc

regards
Hasbullah.com
---

davidefulvio · Mon May 07, 2007 12:10 pm

i have tried to connect with mac telnet and this the answer:
jan/01/2000 00:41:32 system,error,critical login failure for user and via winbox
Terminal linux detected ,using multiline input mode
[admin@Mikrotik] > user print
Flags X-disabled
# NAME GROUP ADDRESS
0 ;;; system default user
admin full 0.0.0.0/0

Diganet · Mon May 07, 2007 12:28 pm

i have tried to connect with mac telnet and this the answer:
jan/01/2000 00:41:32 system,error,critical login failure for user and via winbox
Terminal linux detected ,using multiline input mode
[admin@Mikrotik] > user print
Flags X-disabled
# NAME GROUP ADDRESS
0 ;;; system default user
admin full 0.0.0.0/0

Login as admin

/Henrik

balimore · Mon May 07, 2007 12:39 pm

----
yes, friend you have login in as admin with full permission, now you can start from here http://www.mikrotik.com/testdocs/ros/2. ... /basic.php

i think should working...

regards
Hasbullah.com
----

davidefulvio · Mon May 07, 2007 12:42 pm

I have tried to access through telnet and i access all functions. I have changed IP address and then I have tried to access through winbox downloaded through HTTP but this disconnect every 30 sec and it does not make me to access all functions

balimore · Mon May 07, 2007 12:53 pm

----
when you try login in with ip address, your PC must same range subnet and netmask of your router address.

with mac-telnet or mac-winbox diffrence subnet is no problem

regards
Hasbullah.com
----

davidefulvio · Mon May 07, 2007 1:27 pm

i set this parameters:
ip address 192.168.0.1
subnet mask 255.255.255.0
gateway 192.168.0.254 (ip address of router)
is it ok?

problems with mikrotik router RIC 522 routerboard 112

problems with mikrotik router RIC 522 routerboard 112

Re: problems with mikrotik router RIC 522 routerboard 112