Community discussions

MikroTik App
  4. RouterOS
  5. Forwarding Protocols

2x Mikrotik CCR1072 UDP out-of-order issue

Post Reply
 
Prewest
just joined
Topic Author
Posts: 17
Joined: Tue Oct 20, 2009 3:35 pm

2x Mikrotik CCR1072 UDP out-of-order issue

Wed May 29, 2019 1:47 pm

Hi all,

1st: CCR1072 firmware 6.44.2
2nd: CCR1072 firmware 6.44.3

I have 2 CCR1072 routers in 2 different datacenters, both routers are connected with eachother via a 10GB dedicated link..
Now there are UDP streams going over this link but the packets are one-way out-of-order.

When using iperf (on 2 dedicated debian 9 machines) when going from DC A to B then I get 0% errors and all packets are in order, but when I reverse the test from DC B to A then all packets are out of order which results in corruption of the UDP streams..
All packets are QOS tagged which is working correctly (Using queue tree for the time-critical packets)

I`m using a MPLS/VPLS to bridge to 2 networks.
Here`s the output of iperf of both locations:
Image
Top
 
lomayani
just joined
Posts: 19
Joined: Sat Jun 17, 2017 7:21 am

Re: 2x Mikrotik CCR1072 UDP out-of-order issue

Wed May 29, 2019 2:20 pm

Hi all,

1st: CCR1072 firmware 6.44.2
2nd: CCR1072 firmware 6.44.3

I have 2 CCR1072 routers in 2 different datacenters, both routers are connected with eachother via a 10GB dedicated link..
Now there are UDP streams going over this link but the packets are one-way out-of-order.

When using iperf (on 2 dedicated debian 9 machines) when going from DC A to B then I get 0% errors and all packets are in order, but when I reverse the test from DC B to A then all packets are out of order which results in corruption of the UDP streams..
All packets are QOS tagged which is working correctly (Using queue tree for the time-critical packets)

I`m using a MPLS/VPLS to bridge to 2 networks.
Here`s the output of iperf of both locations:
Image
this normally happen when doing load-balancing between two links and cause udp packet to be out of order
So this might mean there is load-balancing in one direction
Top
 
Prewest
just joined
Topic Author
Posts: 17
Joined: Tue Oct 20, 2009 3:35 pm

Re: 2x Mikrotik CCR1072 UDP out-of-order issue

Wed May 29, 2019 3:25 pm

I just checked, there is no loadbalancer active on that link
Top
 
Prewest
just joined
Topic Author
Posts: 17
Joined: Tue Oct 20, 2009 3:35 pm

Re: 2x Mikrotik CCR1072 UDP out-of-order issue

Thu Jun 20, 2019 9:57 am

If someone runs into the same issue, I have found the problem;

On one SFP+ interface flow control was set on auto, after setting flow control on OFF the problem was gone..
Top
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest
  4. RouterOS
  5. Forwarding Protocols