Hi,

I have a project with two RB4011 in VRRP connect between Eth9 and Eth10 (Bonding). I have a Bridge with the Port-Channel and the SFP+ port and bridge has the IP.
Both have 6.44.3 and when I upgraded them a 6.45.5 or 6.45.6 version the ARP of the IPs through the SFP port don't appear in the ARP table.
If I disable the SFP port and enable again I see the IPs on the ARP table again, but if the MikroTik reboots then the ARPs disapeear.

Downgrading 6.44.3 the MAC returns on the ARP table everytime.

Is there any bug?

Thanks!
Regards,