Hello and good day.

i have an issue/difficulty regarding a cAP AC device.
The problem is, that a reset of the device is not possible after using netinstall.

Procedure:
Netinstall routeros-arm-6.45.5.npk without any config- Success
Reboot (Powercycle/or from within routeros) - Success
Reset - Failure (device doesn't come up in winbox)

LED status:
Power - always on;
Ethernet - blinking (indicating network communication);
2Ghz & 5Ghz blinking rhytmically (2secs)

Any help is very much appreciated.

Kind Regards

Jan

Problem solved

Problem solved

The quoted post is completely useless. You should describe your solution to aide any future users with similar problem.

I'm sorry,
The whole problem dewscription was relaying on a missconfiguration at some oter point, so it couldn't help anyone in no case.
That's why i tryed to delete tho whole Thread. Obviously without any luck.

That's why i tryed to delete tho whole Thread. Obviously without any luck.

Would you like me to delete it for you?

hi, i don't know how to add new post so i will post my problem her as reply to this topic.
my problem is netinstall not working on windows 10,
and showing a message box say
"no code !!!: the opration completed successfule. (0)"
i tried to solve the problem with '' run as admin and compatblity with win 7 but the problem still,
thank u to read my words

If you can
When i tried i got a system message stating it where not possible to delete a post after it was already replyed.