Greetings,

I'm trying to test various VPN solutions supported by mikrotik routers.

For each, I create a new pool, profile and secret.
Profile is declaring local IP and referencing the pool.

Exactly the same thing is done for SSTP, PPTP and OVPN (on a non-standard port that is, however, whitelisted in firewall)

All three establish connection, however local/remote address fields are empty for OVPN.
No NAT is used, just routing (and it seems to work fine for SSTP/PPTP).
I'm sorry I do not know how to share configuration script as I'm new to this stuff and have created all that via GUI.

Tried to set IP addresses in "secret",

Any clues?

Mikrotik's Version of OVPN has been abandoned for years.

When I first started with RouterOS 10 years ago... OpenVPN was the first thing I had to "Give up on," using Mikrotik. I think i can find the exact post where I asked about OVPN being updated to work with THEN CURRENT standards. "Next RouterOS release..." was the response.

Like I typed... 10 years ago.

Tik to Tik... I use L2TP+IPSec. This works well if one side or both have Dynamic ISP addresses.

In case other people run into issue: OVPN was actually working, it was just UI not showing IP addresses assigned to the interface.